Every motorcycle rider must know how to jump start a motorcycle, this is a popular question people ask me in the industry. Whether you need to jump start a motorcycle from a car or motorcycle, you should always follow this in-depth guide that will surely help you with jump starting your motorcycle in reasonable time (Under 15 Minutes).
So, how can you jump start a motorcycle in under 15 minutes? You can jump start a motorcycle with another motorcycle, a car, portable jump starter or push start the motorcycle. These are fairly simple task and you need to make sure you take safety precautions based on your circumstances.
Before You Jump Start Your Motorcycle
There are a few things you should check before you decide to jump start a motorcycle. I recommend this because when I was out riding my motorcycle one morning, it clonked out and I was stressed that the motorcycle had croaked on me. Yet, I didn’t check the kill switch. After that mistake, I will never make a similar mistake in the future, and you won’t either if you read this section.
Again, there are a few things you should check before implementing any type of jump starting. See below for the list.
- Check out the Kill Switch: Sometimes your motorcycle won’t start simply because you have the kill switch activated which isn’t going to allow the motorcycle to start. Where is the kill switch? My motorcycle kill switch is on the handle bar, do some research to figure out where your killing switch is.
- Make sure you have Gas: Checking to make sure you have gas in your tank is a stupid mistake some make, it happens more often than you’d think.
- Check your Spark Plug: Checking your spark plug often is recommended by all motorcycle enthusiasts. Check for excess carbon build-up and clean or replace the parts as needed.
- Pull the Clutch & Be in Neutral: Sometimes this will help start the motorcycle; Simply put your motorcycle in neutral and pull the clutch then try start the motorcycle. From my experience, this helps start my motorcycles when it’s cold out.
You can “jump start” a motorcycle in 4 primary ways, we recommend the first one but if that’s not possible then you can try the other three if accessible.
1. Jump Start Motorcycle with Another Motorcycle
Jump starting a motorcycle with another motorcycle is by far the best way to jump start your motorcycle. There are a series of steps you should follow when starting a motorcycle with another motorcycle.
- Turn off Motorcycles & Put them in Neutral: Make sure you turn off the working motorcycle and put both motorcycles in neutral. This step is often skipped and can lead to errors.
- Find the Motorcycle Battery Terminals: For most motorcycles, the battery is under the seat, if you have further questions about where your motorcycle is located, check out this guide from MotorBikeLicense.com.
- Connect the Jumper Cables: You must have a set of reasonable jumper cables on you.
- Start The Working Motorcycle: Start the motorcycle that is working and idle for a few minutes.
- Try to Start Your Motorcycle: It may take a few tries but try to start your motorcycle. Let both motorcycles run for an additional 5 minutes.
- Disconnect the Jumper Cables: Once you disconnect the jumper cables, hop on your motorcycle and ride the motorcycle for a good 10 minutes so you can give it time to recharge the battery.
2. Jump Start Motorcycle with a Car
Jump starting a motorcycle with a car isn’t recommended, but if it’s the only way you’re getting home then we have listed the safest steps for you so you can follow and get home safely.
You may be asking why it’s not the best option and that’s because a car battery is much larger than your traditional motorcycle. With that being said during this process you may burn/reck the electrical components within the motorcycle since the car battery has much larger amperage.
However, if you need to get home and this is the only option, we have listed how you can do it safely at your own risk.
- Make sure the car is turned off during this process: In fact, make sure the car and motorcycle are both completely off.
- Connect the Motorcycle Jumper Cables: Connect with motorcycle jumper cables as you normally do.
- Try start your motorcycle: Without turning on the car, try start the motorcycles after a few minutes. You will not need to turn on the car in order to get juice from the car battery.
- Disconnect Cables: Disconnect the motorcycle jumper cables and make sure you start with the negative side of the battery.
- Ride the Motorcycle: Now it’s time to ride the motorcycle for at least 15 minutes. This will allow time to recharge the motorcycle battery. However, if you are going to replace the battery, you don’t have to ride the motorcycle for around 15 minutes.
3. Jump Start a Motorcycle with Portable Starter
Jump starting a motorcycle with a portable starter is by far the best option in the books. You don’t need to rely on others having a car, motorcycles or even jumper cables. Especially if you are a single rider, it’s well worth the investment for using a portable starter.
Nekteck Motorcycle Jump Starter
- Portable power source
- Capable of covering 500peak amps with 12,000mAh battery juice
- Flexible and versatile to charge smartphones, tablets, speakers, etc.
- Built-in Led flashlight indicator
Learn more about the best motorcycle jump starters here.
Now let’s discuss how you can use a portable motorcycle jump starter.
- Turn off your jump starter and motorcycle: All power must be off when you start this process.
- Connect the Cables: The next step is to simply connect the cables from the jump starter to the motorcycle battery itself.
- Turn on the Motorcycle Jump Starter: Most motorcycle jump starters are versatile, so make sure you turn the portable starter to the right voltage, so if your motorcycle battery is a 12V, make sure you have that setting configured on your motorcycle portable starter.
- Try Turn on Your Motorcycle: Now you should try to start your motorcycle, you must hold it for a good 3 seconds before you expect it to turn on. If there is no ignition start, let it sit for a few more minutes and give it a try again. If it doesn’t work then, you must start looking at whether the battery is completely dead or not.
- Disconnect the Cables: It’s time to remove the cables from the battery now. Remove the negative cable first.
- Recharge your Battery Starter: It’s time to ride your motorcycle around for a little while and recharge your batter. You must also recharge your portable motorcycle battery starter to ensure that next time you have to use it, that it has enough juice to successfully help you again.
4. Push Start Motorcycle
You should never have to push start a motorcycle, there are too many alternatives to give the excuse to push start a motorcycle. Although this guide is to simply educate you on how you can start a motorcycle when it can’t on itself.
- Find an Open Area / Road: You must find a road or pathway that is open so you don’t put anyone else at risk other than your own safety.
- Put the Motorcycle in 2nd Gear: Put the motorcycle in 2nd gear to ensure that you can push the motorcycle that fast so the engine can initiate power.
- Pull Clutch & Push the Motorcycle: You don’t need to push the motorcycle at an extremely fast speed, just push till your at like 4 Miles per hour. It’s best to find a slight slope.
- Release the Clutch Quickly & Give Gas: This step is the most important and may take a few tries to master this skill. It’s not particularly healthy to dump the clutch as discussed. Once you do this give the motorcycle gas and listen closely the motorcycle will either try turn on or will successfully turn on.
I hope this guide was helpful, so now if you ever need to jump start your motorcycle, you have the appropriate resources necessary to get home safely. Below we have listed a few other questions that I get asked a lot.
Frequently Asked Questions
Can I jump start a motorcycle with a dead battery? There is no way you can jump start a motorcycle with a dead battery, this is important to know because don’t waste your money or time if your battery has nothing. In order to verify that your battery is completely dead, you must determine the Voltage within the battery to determine if the battery is wasted or not. Sometimes it’s easier to visit your local shop to determine your battery level.
Is push starting a motorcycle bad? Push starting a motorcycle isn’t necessarily recommended by us, it’s definitely feasible but there could be some minute issues that arise. However, it doesn’t defect the engine directly, it’s more of a safety problem because you are pushing the motorcycle in possible hazardous areas such as traffic, trees and such.